Sakura HBK-18?23AB Bedienerhandbuch PDF herunterladen (Seite 13)

Regulator Push Rod Connector

1 - Clamp screw.

2 - Push rod connector.

3 - Starlock washer.

Prepare a servo horn with a single arm and four connection

holes. Fit the horn so that it is pointing to roughly half way

between 8 and 9 on a clock face and fix it in place with the

small screw provided. When the left hand control lever is

moved upwards, the servo horn will rotate anticlockwise.

If it travels clockwise, use the servo reverse switch located on

the transmitter then reset the horn as above. Turn the

regulator spindle clockwise with your fingers to close it, but do

not force it. Fit the regulator arm to the spindle with its centre

boss and push rod connector facing the rear, placing it roughly

parallel to the servo horn and nip up the grub screw using the

same Allen key supplied for the wheel grub screws. Using the

1 2 ... 8 9 10 11 12 13 14 15 16

Keine Kommentare

Sakura HBK-18?23AB Bedienerhandbuch Seite 13